Safely supplying pressurized fuel to industrial burners demands attention to detail, quality components and professional engineering. Maxon fuel trains and supply skids assure your ...
Pneumatically actuated valves with powerful closing spring for reliable operation
Factory Mutual, CSA and CE approved safety shut-off and vent valves
Hazardous Location approved: ...
These electrically actuated valves shut off gas or oil lines in less than one second. All shut off valves come equipped ...
DUNGS® gas trains
Gas ...
The FX37SPT is a very reliable electronic ignition controller that is used in many gas appliances ...
FX37SPT/D22 - Ignition Control Box with 22s Pre-purge delay.
The FX37SPT/D22 ...
FX37-EP6 Ignition Control Box
The FX37-EP6 is a direct replacement ...
Pyronics FLOMIXERS are proportional mixing devices that utilize ...
Pyronics Hijectors are designed to use high pressure ...
Superior Performance For Industrial Stand-By Fuel Systems, Utility Peak Shaving And Process Applications.
The Selas Blender Valve accurately mixes a wide variety of gases with air to provide a fuel gas compatible with natural gas. It handles high gas pressures (up to 150 psig or 1034 ...
Pulsed spark ignition device for high-voltage ignition ...
CE CERTIFIED!
Functions:
1, Ignition
2, Flame Detection
3, Auto-shut-off when flame ...
The Hauck Regulator Gas Manifold is a factory assembled and prepiped gas train that permits easy, fast installation. ...
The Hauck PLPM liquid propane manifold is a factory assembled prepiped LP train that permits easy, fast installation. ...
The Hauck Regulator Gas Manifold is a factory assembled and prepiped gas train that permits easy, fast installation. ...
Design guidelines for C-B NATCOM burners are based on aircraft jet engine combustors, where the burner and combustion chamber are fully integrated. ...
Eclipse valve trains are rated for 110-120V / 50-60 Hz operation and are designed to meet the requirements of NFPA 86 - 2003 or Industrial Risk Insurers (IRI) ...
Eclipse Consta-Mix machines are precision gas/air mixers and controllers, designed for use in either pre-mix or standby systems. In pre-mix systems, it is to supply a combustible gas/air mixture to gas burning ...
The Eclipse Minimixer is a minature fan-type mixer fro producing an air/gas mixture and delivering it under pressure to a burner or series of burners.
The Minimixers are normally ...
Gas Trains and Control Systems
We can ...
Pressure reduction and regulation groups allow to bring gas pressure available in the line to values suited to the specific application.Gas trains include a series of safety ...
Valve for water heaters/boilers of up to 60,000 Kcal/h. It ...
The 00 Series gas cocks are Multigas cocks with safety valves, belonging to group 1. They have the following technical ...
The 02 Series gas cocks are Multigas cocks with safety valves, belonging to group 1. They have the following technical ...
The 06 Series gas cocks have the following technical characteristics:
Dp= ...
# Compact design with integrated ignition transformer and flame monitor/burner control
# Built-in flame ionization electrode, ideally located
# No high-voltage cable required on site
# ...
* High energy ignition, Insensitive to moisture
* Material burner tube stainless steel 310
* Material connection enclosure stainless steel 316
* Self-aspirating, forced air supply or combination
...
D-HG 400 High Energy Ignition Device
The D-HG 400 high energy ignition device is suitable for the ignition of gas or liquid fuels in industrial burners of any capacity
Features
Ignition of liquid or ...
The MAXFire® 100 Series gas igniter incorporates the "protected primary combustion ...
Flare Gas Recovery Systems
Pollution control with valuable payback. John Zink designs advanced flare gas recovery systems that enable ...
The purpose of an ignitor is to supply the necessary heat release for startingup an industrial burner.
Taking advantage of over 80 years expertise in combustion, PILLARD propose a wide range of electricgas ignitors which may fit all types of burners for boilers, refinery heaters, process furnaces, hot gas generators,
rotary kilns, and reactors of Claus units.
The ...
