|
|
PART # SBS BCT-5000
DC RESISTIVE LOAD BANK (24, 48, & 120 VDC)
The only way to know your industrial batteries will perform to specification is to test them regularly. SBS's battery capacity testers enable you to test your wet or sealed batteries in a variety of ways and at three voltages. Load bank test 24V, 48V, or 120V DC systems with currents up to 171 amps. A built-in digital meter lets you read volts, amps, amp-hours, and elapsed time without having to hook up a separate meter. The display is accurate to 1% of full scale at the rated voltages. The unit also offers continuous operation, so there's no cool down needed after or between tests. Use the master load control switch to instantly apply or remove loads.
|
|
Our capacitance bridge performs measurements in conditions that are beyond the scope of most conventional Capacitance Bridges, by the use of a well proven transformer ratio-arm design. Test sites such as high voltage switch yards, transformer stations, and production areas with a high presence of electrostatic interference do not have adverse effects on this instrument. Measurements on three or four terminal devices can be done without calculation by the use of the GUARD system. This low voltage test set is designed to test electrical insulation qualities in the laboratory, substation or maintenance shop, without the dangers associated with using a high voltage test set.
Features
* Capacitance testing for precise determination of capacitance and dissipation factor (C&DF)
* Important for preventive maintenance, production testing and cable fault finding
* Extremely useful for measuring dielectric properties of power transformers, bushings, cables, and power factor correction capacitors.
|
|
- Waveform (Range):Oscillation (up to 4 µF, Vmax 6000 V; 4 µF up to 10 µF, Vmax 4000 V)
- Coupling:up to 800 V rms/16 A for <= 6 s / up to 380 V rms/16 A for continuous operation
- Standards:IEC 60348-14 Amd.1,
- Options:EN 132400
- Required Accessory:Coupling Switch Matrix TC-MIG24, TEMA
|
|
|
|
