BN 30339 Speed clips nuts for self-tapping screws Spring steel zinc plated
... with holes The nut is slid onto the panel edge and over the panel hole (or through a second hole when fitted mid panel) The element is positionned over the nut and linally the bolt (and washer if needed) ...
... with metric ST screws The nut must be pushed in the hole, then the element is positioned over the nut and lastly the screw (and washer if needed) is put through it and tightened Permits blind ...
... holes using metric bolts The nut must be pushed in the hole, then the element is positioned over it, and lastly the bolt (and washer if needed) is installed and tightened Permits blind assembly and prevents nut ...
... panel with oblong holes Permits blind assembly and prevents nut rotation With different screw positions absorb assembly tolerances For higher performance, use metal snap in nuts
For a secure threaded connection between two panels
Spring clips can be used on thin metal sheets to obtain a screw housing. They can be double or semi double, for self-tapping or metric screws. They are available in different sizes, according to the thickness of sheet ...
... steel 'J' Nuts are lightweight easily installed low cost fasteners. They are used to provide strong thread forms for thin sheets that would otherwise be incapable of accepting a thread. Manufactured to suit a range of ...
FN Flat Nuts are a very cost effective light weight way of providing thread forms that can be slipped into location areas on components to enable mating parts to be screwed to them. The bow in the clip ...
Application: Use safety clips and bayonet clips on grooved rods or grooved clevis pins instead of the traditional cotter pin. Construction: Spring steel, plated zinc clear.
F = Panel thickness 0.8 - 5.6 170 °C For full Installation Instructions see the PDF document in the ’Downloads’ window or click here Material Spring steel/ zinc-flake coated.
material : Acier ressort support : dimensions : M4 to M8