|
|
MOTORI - Serie 76(Ø76)
Tensione nominale 12÷48V
Giri a vuoto(g/min) 1000÷5000
Potenza resa 5÷90W.
|
|
MOTORI - Serie 62 (Ø62)
Tensione nominale 12÷48V
Giri a vuoto(g/min) 1000÷5000
Potenza resa 5÷80W.
|
|
MOTORS Series Ø42
Supply voltage 12÷48V
No lead speed (rpm) 1500÷5000
Shaft power 5÷50W.
|
|
5inch BZD Serial Pump DC Motor
Voltage : 12-48 V
Power : 2300 - 3000 W
Direction : CW, CCW
Rated Current : 2800 - 3450 rpm
O.D. : 125 mm
BZD-3.3 Serial Pump DC Motor
Voltage : 24 V
Power : 3300 W
Direction : CW, CCW
Rated Current : 3350 rpm
O.D. : 126 mm
4.5inchBZD Serial Pump DC Motor
Voltage : 12-48 V
Power : 1500 - 2500 W
Direction : CW
Rated Current : 2300 - 2600 rpm
O.D. : 114 mm
Small Serial Pump DC Motor
Voltage : 12-24 V
Power : 300 - 1200 W
Direction : CW, CCW
Rated Torque : 1.5 - 3.5 Nm
Rated Speed : > 1430 - 4000 rpm
O.D. : 84 mm
|
|
4-Pole Electrical Designs for High Current Capability
Ball Bearing Construction for Heavier Load and Long Life Capability
High Efficiency Permanent Magnet Designs
Rugged Welded Clip for Magnet Retention, Not Glued
Castings Designed for Maximum Heat Dissipation
1/4 HP - 4HP, up to 5000 RPM, 12-72 VDC
|
|
MODEL SERIES - DC32
PMDC GEARED MOTOR
Design - Motor DC32 is a carbon brush DC motor which is used in combination with many Mech Tex gearheads. The standard gearheads used in conjunction with this motor are GB2, GB5P, GB5H, GB38OCP, GB3, GB4, GB7,GB8 & GBW. Depending on the application, output speed, load applied, etc. the type of gearhead can be selected. Various types of gears i.e. poly acetal, sintered iron, brass or
steel gears can be used based on the requirement. Poly acetal or sintered gears damp the noise. Case hardened steel gears are always on the output for load considerations. Complete poly acetal gears are used when the output torque
required is low. Linear drive is possible with gearhead GB4,GB7,GBW with M6 x 1
mm pitch screw. The linear guide & screw arrangement can be done only on special request.
|
|
MODEL SERIES - DC42/ DC52
PMDC GEARED MOTOR
Design - Motor DC42/DC52 is a heavy duty carbon brush DC motor which is used in combination with GBW gearhead only. Gearhead GBW contains heavily loaded steel gear wheels. The spur gears are fixed on steel spindles which are hardened and polished to a mirror finish & rotate in sintered bushings. The thick output shaft rotates in robust sintered bushings. All the gears are housed in between metal plates & closed by plastic dust cover. All bearings are permanently lubricated and therefore require no maintenance. Linear drive also possible on request.
|
|
| ... products without technical information |
| |
|
|
