|
|
Wide range of relays anf transformers to protect your instalation of earth leakage, overloads, etc.
Nowadays, earth leakage devices are recognised around the world as an effective means of ensuring the protection of people against the dangers of direct or indirect contact with low voltage electrical current.
The main aim of these earth leakage protection devices is to detect faulty earth currents and to act by cutting the electrical circuit, in the event that these currents pose a danger to persons or property.
|
|
Broad product range for all standard applications in the world of instrumentation
Flexible and space saving single and dual channel versions available
Time saving installation due to simple snap on DIN-Rail and connection to PE and ground at the same time
Installation possible in Zone 2 and Division 2
Reduced inventory due to uniform exchangeable fuse
Safety barriers are used as economical interfaces without galvanic isolation between intrinsically safe and non-intrinsically safe circuits. They protect circuits (i.e. cable and apparatus) in hazardous locations. |
|
-Prewiring: The PI basic terminal block can be installed and wired in the control cabinet without pluggable electronics. The required electronic components are plugged in later. They are coded automatically and snapped securely.
-Functional adaptations are an easy matter during the startup phase.
-There is no need to remove the Ex-I conductors in order to replace a module or alter a function.
-Reserves are simple to retain. Only the PI modules that are actually required at startup time are plugged in. |
|
| ... products without technical information |
| |
The HG805A is a « level-dependent ear-muff» . The ear-muff is made up of a black plastic headband (POM), each end piece of which has a stainless steel saddle equipped with two black plastic pistons (ABS) linking it to the cup and used to set the length of the headband. Both cups are yellow plastic (ABS). They contain the electronic modules and electro-acoustic parts providing the level-dependent system control, including built-in batteries. The electro-acoustic restitution sound level can be set with the potentiometer on one of the cups. These cups include a black plastic, foam (PU)-filled (PVC) cushion
Sudden noise impulses at harmful levels are shut out immediately. Blocks out higher frequency, harmful noise, but allows passage of harmless sounds, especially those in speech frequency range Weak sound can even be amplified, so you hear them better than you would without hearing protector ! CE EN352-4. HEADGUARD brand. |
|
Add music and routine jobs become more satisfying. Our Radio earmuffs provide protection from noise %u2013 and let you listen to music from a built-in AM/FM radio.
|
|
Surveys have shown that workers carrying out repetitive and monotonous work are at a greater risk of being involved in workplace accidents. Noise makes people feel isolated, affects concentration and sleep patterns. Here Silentex products can help.
|
|
| ... products without technical information |
| |
FULLTEST4058 model was designed from HT ITALIA to performing essential tests in industrial environments on electrical machines devices and partially type-tested assemblies (PTTA) in compliance with EN60204-1 and EN60439-1 respectively.
The meter principally performing Continuity test on potential equalising conductors with >10AAC test current, Insulation Resistance with 500VDC test voltage and Withstanding tests with 1000AC test voltage (for electrical machine devices) and 2500V test voltage (for individual test on PTTA assemblies switchboards).
Withstanding test is performed also in BURN mode with no limits on trip-out current. Discharging Time measures of internal capacitance and on external plugs of device under test complete the list of possible test with this meter.As FULLTEST4050 more advanced model also FULLTEST4058 have a built-in internal memory to save all measurement results and a RS-232 PCs interface for directly transfer of saved tests by dedicated Windows software.
The model is fitted inside a practical and protected plastic case board with no flammability and a membrane keyboard for rapid selection of functions is included on the frontal panel together a wide custom display.
FULLTEST4058 is the ideal solution for any kind of verifier and/or industrial installer to performing easily and rapid test on industrial appliances. |
|
General characteristics:
- Overload protection with thermal memory
- Phase aymmetry and phase sequence protection
- External display module for panel mounting (22 mm)
- Not connected to the motor line (passing through wires).
- Manual reset: when tripping as result of asymmetry or phase failure, the relay could be reset after 2 seconds; should tripping be caused by an overload, the waiting time to reset will be directly proportional to its severity, up to approximately 8 minutes.
- Remote reset: after the waiting time has elapsed by interrupting the auxiliary power supply and reconnecting it again after 3 seconds.
- Mounted on DIN rail EN50022-35.
- UL, cUL listed. Marked CE.
- Maximum terminal section : 2.5 mm2, No. 22-12 AWG.
- Maximum screw torque: 20 Ncm, 1.8 LB-IN.
- Norms: IEC 255-22, IEC 801, EN 50081-2, IEC-255, IEC-947
- Insulation: 2000V - 50Hz - 1min/3kV - 1.2/50 µs.
- Storage temperature: -30°C +70°C.
- Operation temperature / Maximum altitude:
-15°C +60°C / 1000 m. |
|
Fanox offer a motor protection relay, with ATEX certificate (PTB). It is ideal for motor application on explosive atmosphere.
General characteristics:
- Overload protection with thermal memory
- Phase aymmetry and phase sequence protection
- External display module for panel mounting (22 mm)
- Not connected to the motor line (passing through wires).
- Manual reset: when tripping as result of asymmetry or phase failure, the relay could be reset after 2 seconds; should tripping be caused by an overload, the waiting time to reset will be directly proportional to its severity, up to approximately 8 minutes.
- Remote reset: after the waiting time has elapsed by interrupting the auxiliary power supply and reconnecting it again after 3 seconds.
- Mounted on DIN rail EN50022-35.
- UL, cUL listed. Marked CE.
- Maximum terminal section : 2.5 mm2, No. 22-12 AWG.
- Maximum screw torque: 20 Ncm, 1.8 LB-IN.
- Norms: IEC 255-22, IEC 801, EN 50081-2, IEC-255, IEC-947
- Insulation: 2000V - 50Hz - 1min/3kV - 1.2/50 µs.
- Storage temperature: -30°C +70°C.
- Operation temperature / Maximum altitude:
-15°C +60°C / 1000 m. |
|
General characteristics:
- Pump protection (dry working protection) without external sensor
- Overload protection with thermal memory
- Phase aymmetry and phase sequence protection
- External display module for panel mounting (22 mm)
- Not connected to the motor line (passing through wires).
- Manual reset: when tripping as result of asymmetry or phase failure, the relay could be reset after 2 seconds; should tripping be caused by an overload, the waiting time to reset will be directly proportional to its severity, up to approximately 8 minutes.
- Remote reset: after the waiting time has elapsed by interrupting the auxiliary power supply and reconnecting it again after 3 seconds.
- Mounted on DIN rail EN50022-35.
- UL, cUL listed. Marked CE.
- Maximum terminal section : 2.5 mm2, No. 22-12 AWG.
- Maximum screw torque: 20 Ncm, 1.8 LB-IN.
- Norms: IEC 255-22, IEC 801, EN 50081-2, IEC-255, IEC-947
- Insulation: 2000V - 50Hz - 1min/3kV - 1.2/50 µs.
- Storage temperature: -30°C +70°C.
- Operation temperature / Maximum altitude:
-15°C +60°C / 1000 m. |
|
| Fanox proposes two models of Thermistor protewction relay (PTC). One model is with automatic reset and the other one y manual reset. |
|
| ... products without technical information |
| |
| ... products without technical information |
| |
CABLE PROTECTION IN CONCRETE :
* EUCAVOLT :
PVC-pipes with CEBEC quality label.
* EUCAVOLT-R :
Reinforced PVC-pipes with CEBEC quality label.
* E-FLEX :
Flexible protection pipes.
CABLE PROTECTION IN THE GROUND :
* EUCAPROTECT :
Corrugated PE-pipes. |
|
Characteristics of the product
External diameters: 16 mm - 20 mm - 25 mm - 32 mm - 40 mm - 50 mm - 63 Misters.
Length: 3 meters.
Nanomaterials: Aluminum
The tube of protector of aluminum cables has the following advantages:
- High mechanical resistor.
- Excellent resistor with corrosion.
- Lightness and simplicity of implementation.
- Less expensive than the stainless steel pipe than it can replace in many cases.
- Resistor with sea water.
- Proposed in two versions: with smooth end and has threaded end.
- Non flammable and without release of halogen in the event of fire.
Many accessories such as elbows, smooth or tapped bushings, matter plastic ends, aluminum fixing collars. |
|
| ... products without technical information |
| |
|
|
see the results for the following category
