|
|
These electronic devices, photoelectric sensors or photocells, use the light emission principle combined with the electronic and are made up
of an emitter or luminous source, the light rays of which are detected by a receiver. The variation in luminous signal, obtained when interrupting this ray, is converted into an electrical signal and is measured and used by
an electrical circuit. The light used is either infrared or red. By making use of this light various type of photoelectric sensors can be made. The AECO photoelectric sensors available in the FOTOSTAR range are the FT18M - FT18 -FTQ series in direct reflection, with reflector with polarized light and emitter-receiver versions. Due to their flexibility regarding the various
standard programmable versions these products offer the possibility of stocking reduction and are easily interchangeable with most of the units available on the market. They are used in the field of automation to check for the presence, counting, position control, etc., and they
are compatible with most logic programmers.
|
|
D10 Series: High-performance fiber optic sensors
- Advanced fiber optic amplifier for use with plastic fibers
- Available with visible red or green sensing beam
- Delivers high-performance, low-contrast sensing
- Automatic TEACH options or manual adjustment
- Available in bipolar discrete, dual-discrete or analog/discrete output models
ExpertTM models
- 4-digit TEACH and signal strentgh display or bargraph readout
- Operating status indicators
- Easy-to-set static, dynamic and single-point programming
- Manual fine tuning
- Remote configuration, using TEACH wire
Plastic & Glass Fibres
- Banner offers an unrivalled selection of standard & customised fibres.
|
|
Optoelectronic level sensor
The optoelectronic Senlux Besta level sensors are used for the level monitoring of liquids. Depending on the medium they can be installed as a position-insensitive system.
|
|
AX-250/500PLUS Series are cost-effective long-range dual beams for internal or external applications.
Suitable for external ranges up to 150m outdoors, the beams have twin infrared transmitters and receivers to reduce the potential for alarms from small animals, blowing debris and falling leaves. Beams operate by only triggering an alarm when both beams are broken simultaneously. Initial alignment can be carried out using the built in optical aiming device to roughly set the sensors and then fine-tuning can be carried out using a standard volt meter.
|
|
|
The AX-350DH MKIII and AX-650DH MKIII are the world's first photoelectric detectors with full digital communication. By utilizing digital technology, these products provide easy and highly accurate optical alignment whilst offering a great reduction of false and missed alarms that can be expected under sever outdoor environmental conditions. The advanced structure and IP65 rating make the units highly durable.
|
|
| ... products without technical information |
| |
Digital Fiber Amplifier with Two Independent Outputs.
High speed 60 micro second response.
APC Function (Auto Power Control):
The APC function ensures precise sensing even when there are changes in the temperature or environmental conditions.
|
|
|
|
