|
|
These electronic devices, photoelectric sensors or photocells, use the light emission principle combined with the electronic and are made up
of an emitter or luminous source, the light rays of which are detected by a receiver. The variation in luminous signal, obtained when interrupting this ray, is converted into an electrical signal and is measured and used by
an electrical circuit. The light used is either infrared or red. By making use of this light various type of photoelectric sensors can be made. The AECO photoelectric sensors available in the FOTOSTAR range are the FT18M - FT18 -FTQ series in direct reflection, with reflector with polarized light and emitter-receiver versions. Due to their flexibility regarding the various
standard programmable versions these products offer the possibility of stocking reduction and are easily interchangeable with most of the units available on the market. They are used in the field of automation to check for the presence, counting, position control, etc., and they
are compatible with most logic programmers.
|
|
D10 Series: High-performance fiber optic sensors
- Advanced fiber optic amplifier for use with plastic fibers
- Available with visible red or green sensing beam
- Delivers high-performance, low-contrast sensing
- Automatic TEACH options or manual adjustment
- Available in bipolar discrete, dual-discrete or analog/discrete output models
ExpertTM models
- 4-digit TEACH and signal strentgh display or bargraph readout
- Operating status indicators
- Easy-to-set static, dynamic and single-point programming
- Manual fine tuning
- Remote configuration, using TEACH wire
Plastic & Glass Fibres
- Banner offers an unrivalled selection of standard & customised fibres.
|
|
RiKO FGR-67TG-20 Fiber Optic Sensor
Qualified Sensors From Taiwan RiKO
Fiber with hexagonal sensor head is easy to install and to save space. The strong fiber is covered with metal protective tube or with bend-resistant wire. As the angle of fiber is 90 degrees right angle, it is very easy to install. Especially to be used in a narrow space. Only use one nut, you can install it easily. Additionally, it can avoid the danger caused by revealed fiber and solve the problem to wind the revealed fiber.
|
|
Qualified Sensors From Taiwan RiKO
FRC-310-35FA+FLM03 is a reflective coaxial fiber. A small spotlight made by the lens of FLM03 can be used to make precise positioning or to detect tiny objects. Its distance to focal point is 8 mm. It can be used to detect the mark on the printing paper, or the wafer is unseated in the index table. Minimum sensing object is diameter 0.3 mm.
Our products are compatible with many big brands.
Custom design is welcome.
|
|
AX-250/500PLUS Series are cost-effective long-range dual beams for internal or external applications.
Suitable for external ranges up to 150m outdoors, the beams have twin infrared transmitters and receivers to reduce the potential for alarms from small animals, blowing debris and falling leaves. Beams operate by only triggering an alarm when both beams are broken simultaneously. Initial alignment can be carried out using the built in optical aiming device to roughly set the sensors and then fine-tuning can be carried out using a standard volt meter.
|
|
|
The AX-350DH MKIII and AX-650DH MKIII are the world's first photoelectric detectors with full digital communication. By utilizing digital technology, these products provide easy and highly accurate optical alignment whilst offering a great reduction of false and missed alarms that can be expected under sever outdoor environmental conditions. The advanced structure and IP65 rating make the units highly durable.
|
|
| ... products without technical information |
| |
Optoelectronic level sensor
The optoelectronic Senlux Besta level sensors are used for the level monitoring of liquids. Depending on the medium they can be installed as a position-insensitive system.
|
|
Digital Fiber Amplifier with Two Independent Outputs.
High speed 60 micro second response.
APC Function (Auto Power Control):
The APC function ensures precise sensing even when there are changes in the temperature or environmental conditions.
|
|
RiKO FZ-KP2 Fiber Optic Amplifier
Qualified Sensors From Taiwan RiKO
New All-in-One Amplifier. The most powerful and multi-functional fiber amplifier (built-in NPN No/Nc and PNP No/Nc). FZ-KP2 High speed response time: 0.3msec. It is disigned effectively to solve customers application and storage problems.
|
|
|
|
