Electrochemical carbon monoxide detector with base and ...
Carbon monoxide detector with electrochemical cell. ...
Early detection of fires in coal pulverising mills is essential to avoid catastrophic damage to plant and to avert the threat of injury to personnel. Detection and measurement of carbon monoxide levels produced by combustion within the mill is a proven method of ...
The Model 1010 is a single channel cross-duct analyser for the measurement of CO. It uses an infrared transmitter to project a beam of light across the duct to a receiver mounted opposite. The light beam is tuned to a specific wavelength where the CO molecules absorb the ...
The MYCO2 is a high performance infra-red gas sensor, designed for monitoring environmental CO2 in protected crops and demand controlled ventilation.
MYCO2 is a robust, low cost CO2 monitor, housed in an IP65 rated enclosure against the ingress of water and particulates. The monitor operates on a diffusion/convection principle and therefore no sampling pump is required.
This monitor ...
The Guardian range of infrared gas monitors offers near-analyser quality
continuous sampling, measurement and display of target gas concentrations at an attractive price.
The Guardian SP is a high accuracy monitor offering increased short term stability in lower ranges than Guardian plus models.
For many years, Edinburgh Sensors has pioneered novel non-dispersive infra-red ...
Besides pH and dissolved oxygen measurements, reliable monitoring and control of the CO2 partial pressure is important for successful fermentation. The oxidation ...
THORNTON dissolved ozone sensors are designed for reliable monitoring in the sanitization ...
The Model 2000XTC Transmitter from Teledyne Analytical Instruments resets the standard for thermal conductivity detector based applications ...
Model InstaTrans (3001) Oxygen Transmitter
The Insta Trans is a two-wire, loop-powered 4-20 mA oxygen transmitter packaged within a weather tight NEMA-4 housing. The product ...
Gas sensors series 400, 500, 600, 700 and 800
The gas sensors are connected to the
corresponding units. The sensors are suitable
for ...
From AAI's Micrsopec family of analyzers, the solid state MCP-200 is a direct in-stream monitor designed for dynamic concentrations of IR-absorbing components (e.g. CO2 gas, ...
The BlueInOne analyzer for carbon dioxide and oxygen has been specially designed for monitoring cell growth processes in biotechnology.The device can be installed directly in the exhaust flow of the bioprocess and measures the concentration of CO2 and O2 there in real-time. The BlueInOne Cell automatically compensates any fluctuations of pressure and humidity in the system. The readings are therefore ...
Features
* Measures up to 3,000 ppm Full Scale CO2
* Microflow Detector With High Sensitivity, Minimal Interference, ...
The HLX85 CO2 transmitter is ideally suited for duct mounting in the fields of building management and demand controlled ventilation. The elegant, compact housing enables easy installation directly at the ventilation duct using a mounting flange. The HLX85 C02 transmitter is also available with ...
Low cost and low power
Reproducibility and mass production
One time factory calibrated and compensated modules
Features
High stability and life time
H2, CH4, CO2; He... selectivity ...
The Carbon Monoxide Meter detects the presence of carbon monoxide (CO)
and measures concentrations between 1-1000 parts per million (PPM).
The ...
The Sievers Nitric Oxide Analyzer (NOA 280i) offers the most versatile detection system for Nitric Oxide (NO) analysis. Using GE Analytical ...
Loop-Powered Transmitter
The O2X1 is a small, two-wire, loop-powered oxygen transmitter with an advanced galvanic ...
HCHO Measurement; continuous monitoring or spot checks
FM-801 formaldehyde meter is a portable, continuous measurement formaldehyde (HCHO) meter now available from GrayWolf. A reusable sensor cartridge employs the chemical reaction between formaldehyde and ß-diketone on a porous glass. The yellowing that results from this reaction is measured via photoelectric photometry with accurate ...
Carbon monoxide transmitter
CMT
CMT, carbon monoxide transmitter, is easy-to-use, reliable ...
The LumaSense's Photoacoustic gas monitors are found in many industries and applications. The gas monitors are highly accurate, reliable and stable quantitative gas monitors. Their measurement principle is based on the photoacoustic infra-red detection method and allows measurements of up to 2000 gases, with measuring ranges from ppb to percent concentration.
The gas monitors INNOVA 1412 ...
myDatasens Mobile
Independent operation even at most unfavourable conditions enables an extremely cost effective and maintenance-free measurement network without compromises. The rugged and acid- and alkali-resistant instruments allows you to collect data for your application in a cost optimised ...
The GMT220 transmitter series is designed for a wide range of industrial carbon dioxide applications including greenhouses, fruit storages, safety alerts and demand-controlled ventilation in mushroom farms, livestock husbandry ...
The TDLS200 TruePeak Tunable Diode Laser (TDL) Analyzer is capable of measuring a number of near-infrared absorbing gases in harsh process environments. Able to make measurements ...
SIS presents its new generation of gas VCD ENVOL, T, PT and PTZ.
Compliant with the MID directive, ENVOL was conceived in close collaboration with our customer ...
SIS presents its new stand-alone GSM/GPRS RTU, TAIGA.
Accredited ATEX, its small size makes of the ...
SIS presents its new generation of AMR stand-alone equipment, ...
ProCeas H2S GAS NAT, ...
Inline CO2 Beverage Measurement: Carbo IT, Carbo Inline
Carbo Inline and Carbo IT CO2 sensors for CO2 measurements are installed ...
SYSTEM CO2
WIRE ...
