|
|
. Industry : To warm surfaces and volumes (freezing industry, electronics, automotive, telecommunications, pharmaceutics...).
. Household appliances : Flexible heating elements for domestic equipments (refrigerators, freezers, small domestic appliances).
. Oenology : Must-warmer.
|
|
BS heating cord
Designed to be used in condensate draining pipes, in negative cold rooms.
Available in 40W/m power, BS heating cords have a sole cold lead at one end.
Advantages :
Very flexible, can heat continuously.
|
|
INTERTEC offers the widest selection of explosion-proof heaters worldwide. - CSA/NRTL approvals for America
- ATEX/CENELEC approvals for Europe
- GOST approvals for the Russian Federation
Many other national certificates, e.g. for Japan, the Czech Republic etc.
- For freeze protection
- Installation in a horizontal or vertical position
- Choice of many different wattages
- Self-limiting or with thermostat in the connection cable allowing for quick and easy installation
- Fully factory sealed with silicone, protection degree to IP 68, reliable even in the harshest conditions
- Low thermal stress for long life
- Optional failure alarm
|
|
|
A&N gas line and pump line heaters are designed to prevent condensable gases from clogging your vacuum system process piping. These products are commonly used in semiconductor (IC chip) manufacturing applications. However, our heater products are ideal for any application that requires uniform and controllable process pipe temperatures.
|
|
FV-40BD1H
Thermo Ventilator - PTC Type ( FV-40BD1H )
PTC heater
Integrated muti-functional ventilator
'Alleru-buster filter' equipped
Heater capacity = 2400W
Air volume = 160 m3/h (venitaltion)
FV-40BD1R
Thermo Ventilator - PTC Type ( FV-40BD1R )
PTC heater
Integrated muti-functional ventilator
'Alleru-buster filter' equipped
Heater capacity = 1400W
Air volume = 160 m3/h (ventialtion)
FV-40BD1W
Thermo Ventilator - PTC Type ( FV-40BD1W )
PTC heater
Integrated muti-functional ventilator
'Alleru-buster filter' equipped
Heater capacity = 2400W
Air volume = 160 m3/h (venitaltion)
|
|
|
The Hauck LHO Oil Line Heater is designed to supply the heat necessary to lower the viscosity of heavy fuel oils to that required at the burner for proper atomization. This typically requires lowering the pumping viscosity (nominal 2000 SSU maximum) to the atomizing viscosity (80 - 90 SSU). Auxiliary components can also be supplied to control fuel oil temperature and prevent overpressurization of the oil line heater. Hauck’s LHO’s are available in a wide range of sizes to meet specific application requirements.
|
|
| ... products without technical information |
| |
| ... products without technical information |
| |
Durable fractional horsepower motors are available in sizes ranging from 1/20th to five horsepower and include split-phase, permanent split capacitor, capacitor start, and polyphase models. We offer fractional horsepower motors for a wide range of residential and commercial applications:
Heating And Cooling Equipment
Universal lectricä Blowers: A.O. Smith shaded pole, permanent split capacitor and split phase induction motors are used in residential and commercial furnace blowers. Our 5 and 51/2 inch diameter motors are designed for direct-drive and belt-driven applications and come in a wide variety of mounting configurations.
|
|
APV Compakva
Instantaneous compact water heaters and district heating units
Innovative technology and design
* The smallest unit of its type
* High thermal efficiency
* Low operating costs
* Low power consumption
* Easy to mount and clean
The series of Compakva units ranges from a simple water heater, consisting of a multi-functional block, a plate heat exchanger and thermostatic valve to more advanced district heating units with additional equipment including two plate heat exchangers, pump, expansion vessel and thermometer.
|
|
The highly integrated and easy to operate LHS SYSTEM - line leaves no wish unfulfilled. The air heaters can be externally configured and monitored via the Leister-Bus. As with the LHS PREMIUM - line, the temperature probe, temperature controller and power electronics, as well as device and heating-element protection, are also built-in. With the LHS SYSTEM -line and its operating units and interfaces, you know the status of your air heaters at all times.
• Simple installation of the Leister-Bus with standard network cables (RJ45 connectors)
• Temperature steplessly adjustable
• Integrated probe and temperature controller
• Integrated device and heating-element protection with alarm output
• High process reliability
• Small dimensions, big performance
• Compatible with the existing Leister blower and nozzle range
|
|
| ... products without technical information |
| |
The wte-system - Electrically heated thermal oil and hot water heaters
Thermal oil and hot water heat transfer plants, electrically heated, in more than 30 capacity stages from 3 up to 3.000 kW constitute the wte-system. Thanks to its variety of possible combinations the system practically meets each and every requirement.
Whether for warm water up to 100° C/212° F, hot water up to 240°C/464° F or thermal oil up to 400° C/752° F (special designs up to 450°C/842° F), every temperature range is possible.
All types are also available in explosion-protected design.
|
|
The wtg-system - Heat exchangers
U-, bare and finned tube heat exchangers for virtually all applications, also in high-grade steel, can be supplied by HTT.
The wtg-system comprises various types of heat exchangers with up to approx. 100 m² surface. Acceptance certificates according to almost all classification societies.
The thermal- and fluid-dynamical calculations for the design of the heat exchangers are performed with a powerful software. This software includes temperature-dependent thermal-dynamic properties of nearly all heat transfer media.
|
|
|
|
