|
|
The multifunctional primary test system CPC 100, in combination with the coupling unit CP CU1, is a unique measurement system for: Line impedances and k-factors of overhead lines or power cables, Mutual coupling of parallel lines, Coupling of power lines into signal cables,
Ground impedances of large substations, Step and touch voltages.
The test system offered by OMICRON makes use of frequency shift techniques for accurate measurements regardless of electrical interference. |
|
Euro-Z 290 A adapter
High resolution and accuracy impedance measurement.
Test current up to 294 A, for testing impedance from 1 mW and Isc up to 400 kA. Euro-Z 290 A adapter is a professional portable test adapter.
In combination with one of the instruments EurotestAT, EurotestXA or Eurotest 61557 it performs high precision line and high precision fault loop impedance measurements. |
|
AutoPoint II is a fixtureless, gridless flying probe with a unique power off impedance analysis measurement system. Capable of detecting manufacturing and in-service faults as standard the measurement system is not limited to a single technique.
With the addition of the MiniScanner a wide range of complimentary instruments, whether from DiagnoSYS or an IEEE/GPIB interface instrument supplier, can be added and fully supported by the TestVue32™ operating software. |
|
| The ground resistance of substations can be measured with two auxiliary electrodes which are put into the ground. To avoid influences from the mains current and its harmonics, this measurement should preferably be carried out with 128 Hz.The high output power of the CPC 100 ensures a high ratio of the signal level to the noise level. Thanks to the signal processor technology, the measuring procedure is very selective and disturbances by ground currents are reduced to a minimum. |
|
Earth Testing covers the testing of earth electrodes and the measurement of soil resistivity. The instrument requirements depend on the range of applications.
|
|
Description:
Reads ground resistance down to 0.10Ohm.
- Fully autoranging with data hold to capture readings.
- Convenient alarm and 99-point memory functions.
- Measures up to 30A RMS ground or leakage current.
- Measures currents down to 1mA.
- Accessories included: (1) 9V battery, molded carrying case, test resistance loop. |
|
PART # SBS BCT-5000
DC RESISTIVE LOAD BANK (24, 48, & 120 VDC)
The only way to know your industrial batteries will perform to specification is to test them regularly. SBS's battery capacity testers enable you to test your wet or sealed batteries in a variety of ways and at three voltages. Load bank test 24V, 48V, or 120V DC systems with currents up to 171 amps. A built-in digital meter lets you read volts, amps, amp-hours, and elapsed time without having to hook up a separate meter. The display is accurate to 1% of full scale at the rated voltages. The unit also offers continuous operation, so there's no cool down needed after or between tests. Use the master load control switch to instantly apply or remove loads. |
|
| ... products without technical information |
| |
|
|
see the results for the following category
