Indexing reamers

Diameter : 16 mm - 20 mm

... release it. The reamer has been designed with internal coolant holes directed on each cutting edge for the most efficient head lubrication and extremely long tool life. Advantages High speed/high production No ...

Diameter : 5 mm - 80.29 mm

The MAPAL single bladed reamers are based on the proven MAPAL principle. The cutting of the material and the guiding of the tool are done by precise ground blades and guide pads at the geometrical best positions. Special ...

Diameter : 14.3 mm - 40.29 mm

With the twin-bladed reamers higher cutting speeds and feed rates can be applied compared to single-bladed guide pad reamers. The cutting blades are radially and axially differently set. Dividing the ...

Diameter : 21.83 mm - 47.82 mm

With the twin-bladed and multi-bladed reamers higher cutting speeds and feed rates can be applied compared to single-bladed guide pad reamers.In this case the cutting blades are radially set. Dividing ...

Diameter : 6 mm - 40 mm

... roundness Longer tool life thanks to more cutting edges The most important measure for the performance of multi-bladed reamers is the number of blades. This is limited by the diameter of the tool and by the space ...

Diameter : 10 mm - 50 mm

Indexible insert Reamers type RE, RD, RA and RB Guide for ordering special tools, grinding information, power consumption etc. Range: 10,0-50,0 mm Hard Part Reaming Reaming in hardened Steel and HSS up to 68 HRC. ...