Brake cables used for park brakes and pull-pull cable systems to transmit pull motion between two mechanical devices without the use of rods. Used in applications requiring a high load capacity (1500 lbs) and low deflection (3000 lbs).
... safe, precise, dynamic.
The creativity and many years of experience of our engineers form the basis for innovative products.
HOERBIGER press systems allow you to achieve synchronous positioning accuracies in the µ-range and increased productivity, while guaranteeing the highest demands on operational safety.
Modular systems for most variable requirements:
When exact positioning is required - Systems for CNC-press brakes.
Economical and efficient - Systems for conventional press brakes.
Whenever it is necessary to dissipate power peaks within an electromechanical process in a hot environment, braking resistors come into their own. In certain cases, braking resistors absorb the energy of a motor drive, thereby braking the motor. Each and every resistor designed by JOVYATLAS is suitable for use as a braking resistor.
In general, resistors from our Alpha series or our PT 1000 are used for smaller drives, while our HWS steel-grid resistors or our EN series are suitable for larger drives. JOVYATLAS has a long history of manufacturing braking resistors.
The soft start and braking device of the VersiComb series from PETER electronic, for motor ratings up to 11KW, represents an alternative with a good cost-performance ratio in order to replace star-delta starting in combination with a d.c. braking device.
The devices of the VersiComb II type enable soft start and wear-free braking of three-phase asynchronous motors. Their advantages in comparison with direct-on-line starting or star-delta starting are a torque increase without jerk and current reduction during the starting phase.
This gives the mechanical system and the drive components a longer life.
