SINGLE END TWO FLUTE BALL, 1/32 - 5/16
Most Ferrous, Non-Ferrous and Non-Metallic Materials
Plunge and ...
- Most Ferrous, Non-Ferrous and
- Non-Metallic Materials
- ...
SINGLE END TWO FLUTE
Aluminum, Magnesium, Copper and Zinc
Plunge and Ramp
Pocket, ...
ALMG Series - 2 Flute Rougher
Heavy stock removal (chip load >.025”/tooth)
...
High Performance, chatter free machining provides versatility in Use for all ferrous materials
Designed for use in Titanium, Stainless Steel and all other ferrous materials up to 50HRc
Enables higher spindle speed and heavier chip loads
Eccentric relief on the cutting ...
Coarse pitch, fine pitch, and rougher finisher are all multi-flute ...
Cutting tools
End mills with straight shank carbide
2 flute end mills 2D QC SN
Commercial ...
Cutting tools
End mills with straight shank HSS
2 flute end mills 2D QC SC
Commercial name ...
Granlund now launches a new series of single flute End Mills in solid carbide, for milling, contour-milling and boring in Aluminium, Plastics and Wood. Granlund has developed 3 models: EFA, EFP, and EFT. The singel flute End Mills are recommended for High Speed Cutting. All models are avaliable in the sizes 4, 5, 6, 8 and 10
Singel ...
Slot Drills 2 Flute Ballnose Endmills - Long
- For long-reach profiling & ...
Carbide Burs Cylindrical
- The double cut bur allows for ...
Endmills
Cost effective machining
- Solutions for slotting, ...
Ballnose Endmills are solid carbide milling tools with a state of the art Full Eccentric Relief to maximize the strength and durability of ...
The Flat Endmill Design allows drilling into rough and jagged shaped broken drills or taps where the Armor ...
Corner Radius Endmills are solid carbide helical fluted endmills with a small added corner radius and a state of the art Full Eccentric Relief.
The radius and relief ...
DIXI Polytool has a wide range of standard end ...
DIXI Polytool has a wide range of standard end ...
Type F244...F251
Ball nose end mill solid carbide DIN 6527 + botek standard 2-fluted
Ø 3.000 ...
Type B300
Tap size end mill ...
The ALUSTAR is developped for:
– ...
35° helix
• Suitable for most materials
• Designed ...
Our broad range of TC burrs with 3 mm shank dia. has been further expanded. These PFERD tools are now available in 75 mm shank length versions for problem solving in hard-to-reach areas.
Our existing sets are supplied in a new, highly resistant plastic packaging. Each burr is firmly secured and protected in the new pack. New, too, are two PFERD burr sets comprising the most common head shapes, ...
carbide rotary burr
3210V Standart - cut cross - tooth cylinder
3211V Double-cut cross - tooth ball - nose cylinder
3212V ...
TYROLIT cemented carbide burrs are made from tried and tested types of cemented carbide corresponding to the latest technology. ...
