Newsletter
|
Exhibit on DirectIndustry
The Virtual Industrial Exhibition
Products
Catalogues
News
Videos
Classifieds
Home page
>
Products
>
Search : peel ply
Search results
Peel plies
5 Industrial products
Companies
1 to 3 of 3
Here the first page from the catalogue "ST 70FR - Fire Retardant Glass Structural SPRINT (v9)", which returns results for: peel ply
P. 2
If required,
peel
ply
can be applied over the top of the laminate stack. For a good secondary bond Gurit recommend the use of a non release coated
peel
ply
such as Stitch
ply
A. The
peel
ply
is then covered with a low bleed release film such as P90 or RP2
Here the first page from the catalogue "SE 70 - Epoxy Prepreg System (v5)", which returns results for: peel ply
P. 2
A separate prepreg nylon
peel
ply
is available for covering the mould tool prior to lay-up in order to leave a clean, textured surface for subsequent bonding.The required number of plies of SE 70 prepreg
Here the first page from the catalogue "Ampreg 21 - Epoxy Wet Laminating System (v7)", which returns results for: peel ply
P. 2
Bonding Techniques &
Peel
Ply
It is recommended to use nylon
peel
ply
for any secondary bonding applications.
Peel
Ply
is typically used on laminate surfaces which need to be left to cure or partially cure before further laminating or bonding operations
Here the first page from the catalogue "Ampreg 21FR - Fire Retardant Epoxy Wet Laminating System (v4)", which returns results for: peel ply
P. 2
Bonding Techniques &
Peel
Ply
It is recommended to use nylon
peel
ply
for any secondary bonding applications.
Peel
Ply
is typically used on laminate surfaces which need to be left to cure or partially cure before further laminating or bonding operations
Here the first page from the catalogue "Ampreg 22 - Epoxy Laminating System (v16)", which returns results for: peel ply
P. 2
Bonding Techniques &
Peel
Ply
Where it is necessary for a bonding operation to be carried out following the cure of the Ampreg 22 laminate, a suitable
Peel
Ply
can be applied to the surface to be bonded during the lay-up process
Peel ply for vacuum infusion
max. 160 - 210 °C
Diatex
Peel ply for vacuum molding
max. 160 - 210 °C
Diatex
Peel ply for vacuum infusion
0.6 mm | Compoflex™ 150
Fibertex Nonwovens
Peel ply for filament winding
Fibertex Nonwovens
Peel ply for vacuum molding
Airtech Advanced Materials Group
Catalog search
Gurit
ST 70FR - Fire Retardant Glass Structural SPRINT (v9)
Gurit
SE 70 - Epoxy Prepreg System (v5)
Gurit
Ampreg 21 - Epoxy Wet Laminating System (v7)
Gurit
Ampreg 21FR - Fire Retardant Epoxy Wet Laminating System (v4)
Gurit
Ampreg 22 - Epoxy Laminating System (v16)
Start search in catalogues
recherche-kwref www di En 2012-02-06-12
