Starters

Main features – Version ASAMV – E3: product featuring degree of protection IP54, bypass contactor and line contactor – Version ASAMV – E2: product featuring degree of protection IP54, bypass contactor, circuit breaker, fuses and line ...

It combines the new compact A protector and a PTC starter into one simple and extremely compact package.

Current: 28 A - 430 A
Power: 15 kW - 250 kW

... curve I depending on the application Soft starters enable to cancel inrush currents when starting the motor (6In), without using star-delta start, an autotransformer or resistance at start. Soft starters ...

Current: 9 A - 85 A
Power: 2.2 kW - 55 kW

Meba Motor Starter MBE1-D09 is mainly applied to circuit of AC 50 or 60HZ, voltage up to 550V for far distance making and breaking circuit and frequently starting and controlling motor. It has the features of small volume, ...

Current: 2.5 A - 16 A
Power: 0.25 kW - 2.2 kW

... 0.25 kW to 2.2 kW for all voltages. Ergonomic design, attention to detail and unique features make the SubStartSC® motor starter range your first choice when considering submersible motor protection. In conjunction with ...

Power: 12 kW

The 48 Volt Belt-Driven Starter Generator (BSG) system has been developed for cost-efficient mass hybridization. Functions such as advanced stop-start, coasting and electric boost can save up to 10% of CO2 emissions. ...

Current: 1.2 A - 3 A
Power: 0.37, 0.5, 0.75, 1.1 kW

Characteristics: Chip intelligent control. Automatic into the test condition as soon as starting on; it will cut off automatically when motor in bad operation, to protect the motor. Instead of traditional thermocouple sensor current ...

Current: 9 A - 95 A
Power: 0 kW - 550 kW

1.Application QCX2 series magnetic starter is mainly applied to circuit of AC 50 or 60Hz,voltage up to 550Vfor far distance making and breaking circuit and frequently starting and controlling motor. It hasthe features ...

Features - Increases compressor starting torque for faster recycling - For all permanent split capacitor, single phase air conditioning and heat pump systems - Wired with “Piggy-Back” terminals for easy installation on run capacitors - ...

Current: 9 A

... Functions: - Switching on/off alternating current consumers - Does not allow secondary unwarranted switching on of the starter at transitory lowering of the voltage - Protects the motor from overload in the range ...

... where motor circuit protection is required. GN explosion proof motor starters can be line motors starters or combination motor starters for hazardous applications. The line starters ...

Power: 2.2 kW

... particularly where two drive systems without change in RPM have to be switched on and off softly (as per application). This starter is applied for the soft on-off switching of one independent three-phase AC asynchronous motor.

Non-Reversing Combination Starter provides the ability to turn the conveyor on/off with a disconnect switch. This control also gives the option of running at a variable speed in one direction. Also, this package is used ...

Current: 0 A - 220 A

The flameproof triple pole motor starters Group IIB DE8BA in cast Iron with thermal overload relay are ideally suited for many applications. The range is available in three versions: • with thermal overload relay, without ...

Current: 16, 18, 4, 8, 10 A
Power: 0.37 kW - 22 kW

Electric starter for 1 motor with thermal protection and running capacitor GENERAL FEATURES Power supply 1~50/60 Hz 230V ±10%; Normally open contact for start; Running capacitor; Overload thermal relay externally restorable; Luminous ...

The MS-1P is a concealed compact design packaged with hand/off/auto capability and a wide range class 10 electronic overload (1-16 FLA) so it can function in many applications. The operation allows for manual control of input power. Available ...

Power: 5.5 kW

Enclosed direct-on-line starters for use on AS-Interface line up to 5,5kW/400V. Degree of protection: IP54 Features Non-reversing or reversing DOL starters up to 5,5kW/400V Numerous variants ...

Power: 7.5 kW

... 3. The Star-delta connection is used in order to reduce high currents when starting electric motors. With this 2-stage starter the inrush current (star circuit) is reduced by 1/3 of the height to be expected when starting ...