{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Diameter : 6, 8, 10, 4, 5 mm
Length: 73, 77, 56, 63, 67 mm
... depth of thread should not exceed 1.8 x D (type N5952 up to 2 x D). In long chipping materials, the depth of thread should not exceed 1.2 x D. Lubricate as for tapping. On drilling ...
Diameter : 3 mm - 20 mm
Length: 53 mm - 96 mm
... depth of thread should not exceed 1.8 x D (type N5952 up to 2 x D). In long chipping materials, the depth of thread should not exceed 1.2 x D. Lubricate as for tapping. On drilling ...
Diameter : 5 mm - 38 mm
Length: 133 mm - 349 mm
Diameter : 8 mm - 40 mm
Length: 63 mm - 160 mm
... thinning ≥ Ø 8.000 • web thinning value refers to nom.-Ø d1 • relieved cone • shank with flat • 60° countersink angle • for tapping size holes with centering to DIN 332, sheet 2, form D • application on centring/cut-off machines
This AMECA hand-operated installation tool drilling bit is the ideal unit to use with applications that require a commercially-available standard drill bit. All AMECA ...
Diameter : 6 mm - 120 mm
Length: 27, 25 mm
... use with a non-percussive power drill. The quality of the diamond used in the design and manufacture of EASYGRES drill bits allows drilling of stoneware, porcelain ...
RUBI
Diameter : 3 mm - 16 mm
Length: 62 mm - 123 mm
Short solid carbide 90° step drill, for core hole plus countersink for machine tapping
Cerin s.p.a.
Diameter : 2.5 mm - 10.2 mm
Length: 38, 46, 50, 60, 80 mm
... of hexagonal and cylindrical shank drilling can be performed on nc machines as well as on manual machines with three or four-jaw chucks. 1-5 taps can be remove with one drill to remove jammed taps. Regrinding ...
... Available Special Edge Prep for Additional Tool Life Taper angles are a little more complicated than your standard drill. Namely, the drill diameter becomes smaller the further you go down the shank. Unsure ...
Please specify:
Help us improve:
remaining