"Nivotemp 63 K + KN, 63 K-VA + KN-VA
Modern production facilities employ more and more plant automation systems and computerized controls. These allow the monitoring and control of hydraulic and lubricating systems. Traditional level controls are focused on pump protection i. e. a typical system is equipped with a suppliers of level switch with one or two contacts. These contacts protect the pump from running dry in the event of leakage..
Modern systems provide the opportunity for a pro-active leakage control by the use of continuous signals.
An analog output of 4-20 mA signals continuous signals the fluid level. Deviations from the ""normal"" are detected instantly and can be transformed into many types of action. In case of a catastrophic failure such as a burst professional hose the pump could be shut down immediately rather then let it run until the traditional switch turns it off after a large volume of oil has spilt.
The Nivotemp 63 versions provide continuous analog signals for liquid level only or for level and temperature combined. They are available in two standard length or in 150mm increments. The flange dimensions are the standard ones used for filler/breathers ( DIN 24557/2). In addition the units can be combined with our Fluidcontrolterminal which makes oil care even more technically advanced.
The 63..VA versions are suitable for use with high water based liquids ( HFA).
easy, cost effective installation
continous level / temperature control
4-20 mA analogue outputs
flange standard
one cable for two functions"
Install these compact detection anywhere for accurate point sensing and fast response. All Thermal-Tab modules use a thin-film INDUSTRIAL RTD element. All Thermal-Ribbon models conform to EN60751 Class B tolerance when ordered with a PD platinum element.
- Fast response surface sensing in aerospace, medical and industrial devices
- Rugged lamination construction
- Polyimide, silicone rubber or Mylar™ insulation
Measuring range : from 0/+10 Pa to -10 000/+10 000 Pa
Configurable intermediary and central zero ranges
Air velocity and airflow functions
Interchangeable measuring sensor (SPI technology)
Simultaneous display of 1 to 4 parameters
External professional transmitter unputs (KIMO class 200 and 300) and manufacturer of thermocouple K
2 output 4-20 mA or 0-10 V (4 wires), RS 232, 2 RCR relays 6A/230 Vac
2 visual (dual color LED) and audible (buzzer) alarms
Software, keypad or professional remote control configuration
MODBUS network RS 485 system (optional)
ABS or ALU IP 65 housing, with or without backlit gaphic display
Mounting with the 1/4 turn system with wall-mount plate
CP301 : -100/+100 Pa
CP302 : -500/+500 Pa
CP303 : -1000/+1000 mbar
CP304 : -10 000/+10 000 mbar
• Barbed professional fittings Ø 5,2 mm
• Unit of measurement : Pa, mmH2O, mbar, inWG, mmHG
• Power source : 24 Vac /Vdc, 115 Vac or 230 Vac
• Outputs : 2 x 4-20 mA or 2 x 0-10 V
• Functions : pressure, air velocity, airflow with Pitot tubes, Debimo and other coefficients, integration of measure, self-calibration, measuring correction factor, temperature compensation : manual or automatic (thermocouple K input).
