|
|
Torque Sensor TCU-100
TS-1 is a measure converter that calculates an electrical motors torque in Nm and converts it to an output signal from 0–10 V.
Introduction:
* Torque measuring in a large frequency range 10-400 Hz
* Measuring takes place directly at motor wires. This prevents fault measuring caused by interruption or loss before and inside the frequency inverter
* Its possible to measure the torque from a separate motor when using a shared frequency inverter
* Simple installation even in existing installations, without extra mechanical components
* 24 V DC or AC power supply with galvanic isolation
* External hall current sensor for precise current measuring without the need for main current to flow through TS-1 witch gives a high safety
* Standard analog output 0-10V or 4-20mA
* Calibrations: 500 volt / 200 Amp. / cosö = 1 / 50Hz = 10 volt / 20 mA output signal witch is equal to 276 Nm when using a 2 pole motor with 1 winding trough the hall- sensor LA 205S and 100% range.
|
|
|
Bonded foil strain gages are the time-honored standard for measuring torque and force on mechanical components. Based on many years of experience with this proven technology, Teledyne Instruments offers a variety of torque sensors and load cells for factory, laboratory, and field testing.
|
|
SS-002 - Torque Detector (0.2Nm)
The SS Series has a long performance sales record in a wide variety of applications, including performance tests of motors, pumps, compressors, blowers, boring machine, and gears. Thanks to the economics of mass production, these detectors are as inexpensive as strain gauge types and they are stocked for immediately delivery. High rigidity results from the unitized cast-casing construction.
Specifications:
- Measurement Range: 0.2 Nm
- Minimum Resolution: 0.1 mNm
- Revolution Range: 0 to 6000 r/min
- Moment of Inertia: 4.25 x 10-5 kgm2
- Spring Constant: 1.67 x 10 Nm/rad
|
|
The Torque Sensor comprises of three items: Rotor, Stator, and Power Pack/Digital
Readout & meets the requirements of relevant EU directives.
There are seven sizes of Torque Sensors, which are adaptable to suit most power transmission equipment where torque, power, speed or temperature needs to be constantly monitored.
|
|
|
Crane's CheckStar is an in-line torque transducers with angle measurement options. It sets the standard for dynamic torque and angle measurement of all continuous drive and impulse tools, with proven reliable performance in thousands of applications worldwide. CheckStar transducers fit in-line between the assembly tool and the fastener, measuring the actual torques applied under production conditions.
|
|
| ... products without technical information |
| |
|
|
see the results for the following category :