Vertical-mount pumps

Flow: 0 m³/h - 225 m³/h
Pressure: 0 bar - 9 bar

As an extension to the standard Epsilon range, a vertical pump is available in various materials, including stainless steel or super duplex steels. This competitively priced high pressure pump ...

Flow: 500 m³/h - 50,000 m³/h
Head: 15 m - 110 m
Power: 10 kW - 8,000 kW

S-DVN SERIES Vertical pump for waste water, general industry. Flow rate – up to 50 000 m3/h Power – up to 8 MW Scope of application: Housing and utilities and water utilities Mining industry

Flow: 0 m³/h - 3,000 m³/h
Pressure: 16, 25 bar
Head: 0 m - 180 m

... disassembly of the rotor group for maintenance or repair without distorting pump alignment and suction and discharge piping. • Impeller is double suction. • This feature increases pump suction performance ...

Flow: 0 m³/h - 900 m³/h
Pressure: 20 bar

MCP pumps can be installed in horizontal or vertical position. In warm box execution the pump can remain in cold standby and run in continuous duty. When supplied in cold box execution ...

Flow: 19.44 m³/h - 1,267 m³/h
Head: 4 m - 33 m
Power: 15 kW - 200 kW

Type SPSP(R) pumps are vertical, centrifugal slurry pumps which are submerged in sump to work. They are designed for delivering abrasive, large particle and high density slurries. These ...

Flow: 5 m³/h - 220 m³/h
Pressure: 40 bar
Head: 30 m - 400 m

Design · The OMK-V Pump is a vertical axis, radially split, ring section design multistage centrifugal pump of non-self priming type. · Impellers are between bearings, single ...

Flow: 28 l/h - 840 l/h
Pressure: 16 bar - 220 bar
Power: 1.5 kW

... ruptures. The motor can be both vertical and horizontal installed. Multiplex gear box with one motor drive and pump base is available. Features of LIGAO Hydraulic Diaphragm Metering Pump: Ligao ...

Flow: 170, 160 l/min
Head: 12, 10 m
Power: 0.37 kW

Energy saving   Capacity dry running   Available PP- PVDF       Attacks:   Rigid duct   flexible piping   Flanged

Flow: 0 m³/h - 475 m³/h
Pressure: 5 bar
Power: 0.55 kW - 30 kW

... slurry and affects the pumps by increasing wear and tear. Landia has developed special materials to extend the pump's lifespan significantly in comparison with a standard pump. Landia's ...

Flow: 0 m³/h - 850 m³/h
Head: 0 m - 850 m

... is a horizontal multistage centrifugal pump. RKB/RKBF/RKBK horizontal multistage centrifugal pumps are side suction pumps with vertical delivery and diffuser type casing. ...

... clean water and liquids that are not chemically aggressive towards the materials from which the pump is made. The high efficiency and adaptability of these pumps to even the most unusual of applications, ...

... Aturia, is a vertical shaft centrifugal fire pump, suitable for extensive industrial and municipal applications. This device consists of submerged impellers placed in a series-bowl assembly at the bottom ...

Flow: 30 m³/h - 1,200 m³/h
Head: 95 m - 285 m
Power: 21.5 kW - 204.4 kW

Vertical lineshaft pumps available with flanged drive head for electric motors, with horizontal right angle gear, with overgear driven by tractor p.t.o and with vertical pulley.

Flow: 400 m³/h
Pressure: 48 bar

DV vertical pumps are designed to accomplish easy fluid suction from wells, cisterns, barrels and tanks. Their reduced dimensions and partial immersion design reduce the negative head. Different cone ...

Flow: 0 m³/h - 12 m³/h
Head: 90 m
Power: 1, 3 ch

... laboratories, leisure parks and marine vessels. The pump can be constructed from either stainless steel 304 or 316 and is fully WRAS approved. It can be supplied in either horizontal or vertical configuration, ...

Flow: 2 m³/h - 150 m³/h

... : 2 m³/h – 150 m³/h | 8.8 USGPM - 660 USGPM Range U is installed universally either on vertical piping or on a supply tank with direct connection to a seepex pump.

Flow: 400 m³/h - 80,000 m³/h
Head: 30 m

... drainage for low-lying area、lake area. Structural Characteristics ZL type axial flow pump is vertical structure,and is made up of pump casing and rotating parts. Pump ...

Flow: 5.5 m³/h
Head: 7 m
Power: 300, 160 W

... .11414), switch-on point approx. 2,5 cm, switch-off point approx. 3 mm vertical pressure outlet 1"MPT with hose connection DN 25 integrated non-return valve puddle pump FSP 330 with ENS ...

... located at the bottom of the pool and is fixed by the feet, so the operation is very stable. OU vertical pump is suitable for conveying almost any liquid medium, including water, ...

Fluid temperature: 60 °C
Weight: 28.5, 30 kg

• Pump Type: Rotary - Gear • Flow: 1L / Rotation 
 •
Mounting: 2" MNPT Bung Adapter 
 • Suction Tube Length: 40" Maximum 
 • Inlet: 1-1/4" O.D. 
 • Outlet: 1" O.D. Spout 
 • Wetted Parts: Cast Aluminum, Plated Steel, ...

Flow: 0 m³/h - 300 m³/h
Head: 0 m - 28 m

The FROTH PUMP is of heavy duty construction, designed for continuous pumping of highly abrasive and corrosive frothy slurries. It has a vertical shaft configuration and comprise a hopper, with vertical ...

The (XY)SPR submerged pump is a vertical centrifugal slurry pump, suitable for conveying abrasive or corrosive material. The pump is generally immersed in a pool or pit ...

Flow: 0 m³/h - 5,000 m³/h
Pressure: 20 bar
Fluid temperature: 160 °C

... 160 ºC Maximum pressure: p up to 20 bar Speed: n 50 Hz: 1450, 960 min-1 60 Hz: 1750, 1160 min-1 Vertical shaft split case centrifugal pump, double flow radial impeller, single-stage, balanced ...

Flow: 0 m³/h - 60 m³/h
Head: 0 m - 20 m
Power: 0.37 kW - 20 kW

The pump volute shall be of cast Iron as per grade FG 260 of IS 210/ISO 186 with vertical discharge port. The pumps shall have non clog semi open impeller with material of construction ...

Flow: 6 m³/h
Head: 7.5 m
Power: 0.75 ch

vertical centrifugal pump are high-performance pump for fixed installations with pump immersed directly in the tank and operated by a direct-drive electric ...