|
|
| Frequency converters from 14 to 200 has - 42 V - 200 Hz for electric vibrating needles 42 V - 200 Hz |
|
| ... products without technical information |
| |
The HF25 Series controls address the challenges of microjoining. Miniature welds are highly sensitive to small heat profile fluctuations in the resistance welding process. Overheating deforms and destroys parts, while under heating results in a weak, unacceptable bond. To achieve consistent, reliable welds of small to microminiature parts, precisely controlled heating is required. This necessitates superior control of the energy output.
|
|
The HF27 High Frequency Inverter precisely controls and monitors electrical AND mechanical weld parameters. Miniature welds are highly sensitive to small heat profile fluctuations in the resistance welding process. Overheating deforms and destroys parts, while under heating results in a weak, unacceptable bond. To achieve consistent, reliable welds of small to micro miniature parts, precisely controlled heating is required. This necessitates superior control of the energy output.
CONTROL FEATURES:
Constant current, voltage, and power modes
Monitors energy and resistance
Force control
Monitor displacement and force
Max 2400A at 25kHz electrical feedback |
|
Variable Speed Pumping Systems - Technologic 5500 Series (multiple pump, multiple zone pump controller, )The Technologic 5500 pump controller is designed to provide optimum performance, reliability and energy savings. Receiving sensor inputs, staging pumps, controlling AFD speed and monitoring the motor performance to meet system demands are the overall functions of the pump controller.
The Technologic 5500 Controller combines PID functions, setpoint modification, and system and component status into a single, central, user-friendly unit.
A data-logging feature provides historical information of key events with date and time stamps. Log information includes alarms, pump run timers and pump cycle counters. The signal log displays the minimum, maximum and current values of the process variable and flow. It is also capable of displaying kilowatt-hours. |
|
The M021P is a PID pump speed controller for accurate temperature regulation of hot water in a storage system.
It controls the temperature of the secondary water flow within a heat exchanger by regulating the hot water flow through the primary of the same heat exchanger.
A very accurate temperature control results and hot water can be obtained at mains pressure. |
|
| ... products without technical information |
| |
| ... products without technical information |
| |
... see all the products in the category
UPSs
|
FemtoPower1060-x-s are passively mode-locked 300 fs fibre lasers operating in the 1060 nm spectral range and delivering up to 5 W of average power.
The lasers consist of a master source, high power fibre amplifier and optical pulse compressor. The lasers are air-cooled, maintenance free and do not require any adjustments.
APPLICATIONS
Fundamental study
Micromachining
Bio-medical
Metrology |
|
FT-NAM-I-CFG (604 000)
• 6,2 mm. Housing width
• Namur sensor, dry contact inputs
• DIP switch configurable frequency ranges and output signal ranges
• 3 port 1500 VRMS isolation
• High precision conversion
• Wide operating temperature range
• Low power consumption
The FT-NAM-I-CFG configurable frequency transducer converts measured values of namur sensors and dry contacts into standard current and voltage signals or its inverse.
Input type, frequency ranges and output range are field configurable by means of easily accessible dip switches or can be specified when ordering. |
|
| The Blancett Frequency-to-Current (F-to-I) and Frequency-to-Voltage (F-to-V) converters are microprocessor-based devices designed to provide an analog output directly from a Blancett turbine flow meter. The converters measure and calculate the flow rate of a turbine flow meter and produce an analog output representative of that flow rate, in the form of a 4-20 mA or 0-5 VDC signal. |
|
| ... products without technical information |
| |
|
|