Brush deburring machine
4" - 46", 2 HP | 1000-SA-14
Abtex Corporation
Our single head end deburring machines are available in either a manual or a semiautomatic configuration. Within the system, a disc brushing tool is rotated on the vertical plane, and the extrusion end is presented, in a controlled manner, to the face of the brush by the deburring equipment.
A. Manual System: Setup and operation of this deburring machine requires minimal training. Necessary adjustments for extrusion dimensions and desired brush penetration are easily made. The operator then secures the extrusion to the table with the clamping "arm" and begins to move the table through its range of motion. The extrusion end is first passed through the upper half the deburring brush. As the table reaches its travel limit, the motor/brush assembly indexes upward, and the extrusion returns through the lower half of the brush, completing the deburring cycle. Cycle time is variable.
* Single end deburring machines accommodate parts measuring from 4" to 46" in length.
* Table extension is available for parts over 46" in length.
* Fixturing can be designed to accommodate parts measuring less than 4" in length.
Utilizes 2 HP, 1750 RPM motor.
* Variable speed drive is available for brush motor.
B. Semi-Automatic System: The ease of setup and 360° brush deburring action found in the manual deburring machine are also inherent in the semiautomatic machine. Once the operator has loaded the extrusion(s), two palm buttons are pressed.
-
video
