High watt density cartridge heater
50 W/cm², 75 - 2 500 W
acim jouanin
- Whether they are kept in stock or not, standard cartridge heaters are manufactured according to high density technology.
- This technology requires a H7 bore fit
- Stocked cartridge heaters are available within 48 hours, within the limit of our stock.
- Maximum watt density over the surface of the cartridge can reach 50 W/cm², under specific conditions.
- Rated Wattage : from 75 to 2500 W.
- Rated Voltage : 230 V single phase.
- Stainless steel sheath.
- Ceramic end cap protecting the connection leads.
- Standard connection leads ; flexible multi strands, nickel core wire with fiberglass silk silicone impregnated insulation.
- Tolerance over the length : L < 100 mm : ± 2 mm.
L ≥ 100 mm : ± 2 %.
- Manufactured in accordance with EN 60335-1 standards
Tolerance over the wattage : +5% -10%
Leakage current < 0.5 mA/kW
- Some standard cartridge heaters can be fitted with built in "J" thermocouples (shown in the table as P+tcj), see the layout sketches and the assembling recommendations p.8 & 16. In this case, the standard length of connection leads and thermocouple wires is 1000 mm.
- Our full range of cartridge, from the table below, is UL recognized by Underwriters Laboratories for the USA and Canada.
- Standard cartridge heaters can be fitted with several types of connection and/or accessories
- Special manufacturing : odd sizes, variable power zone, built in thermocouple
-
zoom
