The R-M55H profile benders design was developed from the R-M55. It has the same 2" Schedule 40 pipe capacity, as the R-M55 but incorporates an industrial grade hydraulic system to control the top forming roll. This takes less effort and time on the operator to achieve the same radii. In addition to the hydraulic movement there is also a digital readout to let the operator know exactly where the top shaft is positioned. This is very important for repeating bends.
The R-M55H has a powerful direct gearbox drive system that delivers full torque when bending at full capacity. The R-M55H uses an inverter that is overload protected, to control the rolling speed. Being variable speed allows the operator to fine tune the rolling speed for each material. It only requires 220 volts of single phase power to operate and it can be operated in both the vertical mode for small rolling projects, as well as in the horizontal mode for large rolling projects as there are feet on the bottom and back of the machine.