Safe connection for motor control center Baker

features:

Safety
Opening of MCC after installation not required for testing.
Long term data acquisition possible.
Only high impedance port (0V) external to MCC when Explorer not connected.
Fused
Multiple Isolation Level.
Purely passive device when Explorer not connected.
CT Output: Voltage (no danger to operator with open or short circuit).

Ease of Use
Only one +/- 5 Volt bus connection required.
Only one step data acquisition
Safe electrical on-line testing within 40 seconds without interruption of motor operation.

Consistent Results
No Risk of Misconnection
Gain values of sensor array stored in EP.

Accuracy of Results
Calibration values stored in EP.
Motor ID imbedded in EP.