Pull-type scraper
3.05 m , 13 m³ | SP-C17
Bell Equipment Co SA
Self sharpening, Reversible, 3 piece blade made of special abrasion resistant steel. Blade can be bolted on with a flat bottom for smooth cuts and fills, or bolted with the center bit dropped down (frost or stinger type) for easier loading
HYDRAULIC REQUIREMENTS
Three (3) hydraulic control valves are used to operate the basic scraper. Two (2) hydraulic control valves are required if the optional sequencing valve is ordered. One (1) hydraulic control valve is required if the optional multiplier valve is ordered. Hydraulic circuit requires 2000 psi min and minimum flow of 12 gpm. One (1) more hydraulic circuit (in addition to the above) is needed for the optional ripper attachment.
-
zoom
