Enclosure for control panel
max. 35 x 261 x 180 mm, IP54 | CombiBac
Bopla Gehäuse Systeme
CombiBac
The built-in enclosure system
This flat polystyrene operating front was designed for use as a machine operating panel.The wraparound seal provides IP 54 protection in respect of the installation area. The front surface was lowered especially for the protected fitting of membrane keyboards or other front elements. The installed electronic components can be protected by means of a sheet metal hood mounted on the back.The design and construction of these special hoods makes low-cost processing possible, also for small series.A special flush-mounted frame is available for flush-mounted assembly.Good EMC screening is achieved by the later application of metal coatings on the front lid.
The built-in enclosure system
This flat polystyrene operating front was designed for use as a machine operating panel.The wraparound seal provides IP 54 protection in respect of the installation area. The front surface was lowered especially for the protected fitting of membrane keyboards or other front elements. The installed electronic components can be protected by means of a sheet metal hood mounted on the back.The design and construction of these special hoods makes low-cost processing possible, also for small series.A special flush-mounted frame is available for flush-mounted assembly.Good EMC screening is achieved by the later application of metal coatings on the front lid.
