- Can be used as scrap chopper synchronized with the press or on its own.
- Synchronism with the press is effected by a proximity sensor reading off one of the press cams or by a microswitch contact.
- There is a fixed lower blade and the upper blade and the upper blade is mobil and inclined like a guillotine.The blades are manufactured from hardened and ground steel.
- The shearing pressure is applied by pneumatic cylinders with electrovalve. The cylinder piston rods press directly upon the upper blade.
- The blank holder with springs reduce the screw dislocation.
- The hydraulic power pack with heat exchanger provides a working pressure of 100 bar, until 60 pulse at the first.
- The upper blade holder run over columns with lubricated bushings.
- This scrap chopper cut in small pieces the scrap.
- Usually it's managed by a feeder's numeric control. If it's acquired without other machinery of a line, it must be equiped of a electric cabinet.
- Strip thickness from 3 to 5 mm.
- The cylinder and pump can be designed to suit your requirements.
