Angular position sensor AN9 series

non-contactmagneticHall effect

Non-contact, intrinsically linear contact angle position sensors with two independent outputs. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output (ratiometric to the input voltage) corresponding to an angular rotation of the input shaft Features • Angular position sensor with high tolerance for misalignment • Non-contact angular position sensing and full 360⁰ rotation • Dual independent (redundant) outputs assure high reliability • Custom programming available for: angle range, slope, PWM output, custom magnets - contact factory • No mechanical interface means no parts to wear out or jam • Comes with 18 AWG 305 mm (12”) wire leads • RoHS Compliant • IP68* • Maximum air gap of 5.5 mm (0.22”)** Typical Applications • Implement (fork lift, agricultural trailer hitch, etc.) position sensing • Steer, throttle by wire • Gear selection • Zero-contact encoder alternative • Replacement for smart bearings • Outboard trim sensing