General Specifications • temperature of use : -20° to + 80°C • antistatic following standard NF T 47 104 • V belt sections following standard E 24 - 213 • resistant to oil projection, hydrocarbure and diluted acids. Approved by API (American Petroleum Institute) • endure centrifugal strength • good draining of heat at high speed • reduce bulkiness of transmission : - smaller and lighter pulleys - smaller protection carter - higher speed solutions Stocking conditions Belts must be stocked under the following conditions : • the room must be dry, without dust and well ventilated. • temperature must be between +5°C and +25°C. • no condensation, maximum humidity of air : 65 %. • avoid direct sun light and high artificial light due to ultraviolet. • avoid contact with chemical products, solvent, petrol, lubricant, acid, volatile components, greases. • no material which can produce ozone, like high tension electric material, electric motors or other materials which can produce. sparks or electric discharges. • the stocked belts must not have been stressed, compressed or deformed. • set them more than 1 meter from radiators or heat source. • avoid direct contact with some kinds of metal (copper, manganese, ...) • avoid contact with sharp, abrasive and angular surfaces. • the material of boxes, packings and the coverings must not contain nocive substances for the belts like copper or creosotes.