Timing belt drive
Cross & Morse
They are highly versatile in application and speed range.
Timing belt drives are positive and offer accurate synchronisation of speed, and often make possible worthwhile economies in the design of a machine, because they require less space, reduce bearing specification, eliminate tension devices, yet assure an unusually high degree of efficiency. Virtually every industry has tested and approved timing belt drives. They have been adopted as standard equipment by a wide variety of machine builders and equipment manufacturers. Millions of successful drives in operation without belt replacement for more than five years bear testimony to these drives. Cross & Morse offer three types of timing belt drive to cover the full spectrum of industrial requirements.
Classical Timing Belt Drives
These are the original tooth belt drives, Cross & Morse offer complete drives to1/5" (XL), 3/8" (L), and 1/2" (H) pitch sizes with both pilot bored and taper bored pulleys. Drives to other configurations can be supplied to order.
Metric Series HTD Belt Drives
Cross and Morse combine RPP belts with std. Metric pulleys to provide off-shelf drives in 4 pitches; 3mm (3M), 5mm (5M), 8mm (8M), and 14mm (14M). Further development created RPP Plus Belts in 9mm (8H) and 14mm (14H) pitch with double power capacity.
Polyurethane Timing Belts
Polyurethane belt drives are available in 3 pitch sizes, 2.5mm (T2.5), 5mm (T5 & AT5) and 10mm (T10 & AT10), with a selection of pilot bore pulleys.
-
video
