People at DINSE are not surprised by this success. The system is considered an excellent application solution on the market. This is all down to the newly developed TIG torch head which offers a winning combination of high welding performance and small, compact design. This permits very good accessibility to the component, especially when working with difficult geometries. Added to this is the fact that DINSE also makes full use of the strengths of its overall systems in the TIG system. Through the modular system of welding fittings, all finely turned to one another, shock sensor, wire feeders and the spool holder, DINSE supplies equipment, the detail of which is intelligent while at the same time long-lasting and robust. As with all the welding technologies produced by DINSE, the wire feeder is integrated into the welding fittings using tried and tested PUSH-PUSH technology. The maximum torque of the first motor can be adjusted so that the filler wire cannot buckle out. The second wire feeder is speedcontrolled and provides just the volume of filler wire required. Safe, constant wire feed is therefore ensured regardless of torsion, inflexion and length of fitting, especially when working with thin and soft wires over long distances.