Plate bending machine with 3 drive rollers
2 050 - 4 100 mm | HRB-3 and HRB-3V Durma

3 rolls plate roll bending machines are more precise,faster, more productive and safer plate roll benders by its user friendly operations without dependence to operator competence.

They are suitable for medium and thick plate bending. Unlike the usual cylinder machines, the lower rolls move horizontally to right and left and the upper roll moves up and down. As at 4 roll Machines steel load parallel to the floor so machine pit can be at machine working level

HRB-3:
The side rolls approach to the upper roll and the upper roll pressures the plate from top; this way pre- bending both sides of the plate is possible without taking it off.

HRB-3V:
With the System functioning upper roller trainer can be used as a traditional press. Forming operations and calibration of the welded tubes finishes.
The Sheet is controlled by tightening of top and bottom rolls. This operation does not allow the sheet is skid and fall down. The machine can also be installed below the ground.

PLEASE ASK FOR DETAIL SPECIFICATIONS