Products > Hand tool > Metal disintegrator > ELECTRO ARC

Metal disintegrator for broken tap and drill bit
1295x1003mm | ELECTRO ARC

The HK Series is our most fully equipped heavy-duty table top disintegration work center. The vertical duplex cross-arm support system gives you the rigidity you need at the full reach of the big 813MM (32") cross-arms. Re-circulating cross-arm ball bearings give the head support fingertip-touch ease of movement for fast and easy setup and work piece changeover.

Machines from this series are an excellent choice for high-production manufacturers of larger castings such as diesel engine blocks and heads, and heavy-equipment components.

Standard features:

* 1295MM wide x 1003MM deep (51" x 39.5") cast iron work top with machine-ground surface and eight T-slots to secure the work piece.

* Steel base cabinet of heavy reinforced steel frame construction. Holds 4000-lb.-capacity work top 813MM (32") above floor on six machine levelers with heavy-duty rubber-wheel casters to allow repositioning.

* The disintegration head support system (superstructure) consist of a 70MM (2 3/4") diameter column with 1270MM (50") inches in length. The cross arms are 38MM (1 1/2") in diameter and are 762MM (30") long. Set up and head positioning is fast and easy with our re-circulating ball bearing packs guiding the head in and out with the touch of a finger.

* The HK10QT disintegration head support system (superstructure) offers a massive 1270MM (50") high 114MM (4 1/2") diameter column and two 915MM (36") long by 57MM (2-1/4") diameter cross arms that provide tremendous vertical rigidity for accuracy over the long haul. The cross arms rotate 335° around the column; and the head rotates 360° around the cross arm assembly.