Cross belt auto-sampler for conveyor belts
PCB Series
Eriez Magnetics Europe Limited
The unit has a single direction motion which sweeps the belt clean and discharges the material into a fixed type collection chute positioned at the side of the trough belt conveyor.
The Cross Belt Sampler comprises of a sample cutter attached to a drive shaft carried in bearings which are mounted on a channel section baseframe. This is positioned directly above the trough belt conveyor.
The baseframe is usually fixed onto a support structure anchored at the local floor level or to the conveyor stringers.
The main features are:
* Samples direct from the belt.
* Stainless steel construction.
* Wall-mounted controls.
* Wire mesh guard protects operator during observation.
* Meets BS1017, ISO and all international sampling standards.
* Suitable for most types of trough belt (including deep trough type).
* Designed for operation on all types of granular material.
* Capable of high frequency operation (primary increments of 1 every 15 seconds).
* Minimal installation work, particularly in retrofit situations.
* Suitable for both open and enclosed situations.
* Supplied with protection features to conveyor belt.
* Minimum maintenance.
* Operates on high capacity conveyors (e.g. 4000tph coal).
* Easy to transport - suitable for mobile sampling.
-
zoom
