Nitrogen wave soldering machine
POWERFLOW N2
Ersa GmbH
The Ersa POWERFLOW N2 - a full nitrogen tunnel wave solder machine - was specifically designed to meet the challenges of lead-free soldering! Being Ersa's flagship machine, the POWERFLOW N2 can reduce lead-free wave solder running costs by as much as 90%!
The machine highlights a 16" board width, plug and play pre-heat design (medium IR, convection, short IR and now with new top-side convection) and 1.8 meters of preheat standard. Additional pre-heating of up to 2.4 meters can be added if needed.
A new nozzle configuration brings the chip wave closer to the laminar wave for reduced solder defects. This machine has a pin & chain transport throughout the fluxer and pre-heater and feeds into a finger conveyor in the wave section of the machine.
A bar code scanner on the new fluxer allows to selectively flux and program in "keep out areas" for board cut outs, where the fluxer will not spray a specific area of the board.
The POWERFLOW N2 machine has a process gas cleaning system (similar to Reflow machines) which also regulates the Auto Tunnel Temperature Compensation.
The machine has a low profile design of 1.57 m and is ideal for demanding customers who require a 400 mm or 16" tunnel wave.
The machine highlights a 16" board width, plug and play pre-heat design (medium IR, convection, short IR and now with new top-side convection) and 1.8 meters of preheat standard. Additional pre-heating of up to 2.4 meters can be added if needed.
A new nozzle configuration brings the chip wave closer to the laminar wave for reduced solder defects. This machine has a pin & chain transport throughout the fluxer and pre-heater and feeds into a finger conveyor in the wave section of the machine.
A bar code scanner on the new fluxer allows to selectively flux and program in "keep out areas" for board cut outs, where the fluxer will not spray a specific area of the board.
The POWERFLOW N2 machine has a process gas cleaning system (similar to Reflow machines) which also regulates the Auto Tunnel Temperature Compensation.
The machine has a low profile design of 1.57 m and is ideal for demanding customers who require a 400 mm or 16" tunnel wave.
