Drilling motor-spindle
F.CN24.120
EUROMA
Numerically controlled programmable unit.
- Suitable for: drilling, tapping (in the standard configuration, compensating spindle is recommended), reaming and spot fac
- Spindle drive = Three phase asynchronous motor and toothed belt.
- Quill feed = rolled, precision 16 mm dia. x 5 mm pitch ball screw, pre-loaded to "0" back lash. Toothed belt drive = 1:1 (or otherwise) ratio, and brushless motor mounting (not supplied, but to be specified) provision
- Quill position limit switches = n°1 forward, n°1 at rest, n°1 "0" point.
Unit must be ordered complete with one of the following output spindles:
ISO 30 taper = AT 11
28 mm dia. straight bore DIN 55058 = AT 10
