Pneumatic drilling unit
75 mm, ø 14 mm | F.P13
EUROMA
Working stroke 75 o 150 mm
Total, fast, slow strokes are all independently adjustable.
Coaxial quill thrust and Hydrocheck unit.
Deep hole drilling (more than 4 x dia.) is possible with pecking device F.KD.
For pneumatic cycling use 1/4" BSP 5/2 single acting solenoid valve, and on hydraulic, 4/2 single acting.
Micrometric stroke adjustment F.MIC on request.
The unit must necessarily be ordered together with the following component:
Output spindles:
B12 Taper DIN 238 = AT 1 Code 28010012
ER20 Collet holder (1÷13 mm cap.) = AT 3 Code 28010016
16mm dia. straight bore DIN 55058 = AT 4 Code 28010020
N°1 Morse taper = AT 5 Code 28010024
Hydrocheck units:
50 mm stroke K.50 Code 10420025
75 mm stroke K.75 Code 10420030
100 mm stroke K.100 Code 10420035
Total, fast, slow strokes are all independently adjustable.
Coaxial quill thrust and Hydrocheck unit.
Deep hole drilling (more than 4 x dia.) is possible with pecking device F.KD.
For pneumatic cycling use 1/4" BSP 5/2 single acting solenoid valve, and on hydraulic, 4/2 single acting.
Micrometric stroke adjustment F.MIC on request.
The unit must necessarily be ordered together with the following component:
Output spindles:
B12 Taper DIN 238 = AT 1 Code 28010012
ER20 Collet holder (1÷13 mm cap.) = AT 3 Code 28010016
16mm dia. straight bore DIN 55058 = AT 4 Code 28010020
N°1 Morse taper = AT 5 Code 28010024
Hydrocheck units:
50 mm stroke K.50 Code 10420025
75 mm stroke K.75 Code 10420030
100 mm stroke K.100 Code 10420035
