Tool testing and presetting software
ImageController1
EZ Set
* The vision system recognizes cutting edges over 90° throughout the entire measuring window
* Fine adjustment is not necessary
* Target values can be defined
Edge inspection
* Cutting edge in incident light at 12-fold magnification to check for wear and tear at cutting tools
* Light adjustment with 12 long-living power LEDs
Counter mode selection
* By switching the counter mode e.g. to absolute measure, differential measure or chain measure you can easily measure e.g. distance of step length
Zero point monitoring
* If the operator forgets to change the adapter zero point during an adapter change, there is the risk of wrong measurement results
* In order to prevent these, EZset offers as standard the zero point monitoring - a security question for the operator
Measurement concentricity/axial runout
* Measuring programs to determine e.g. oversize radii and angles, concentricity and axial runout, largest and smallest cutting tool
* Print measurement results comfortably on a label
-
zoom
