Cast steel gate valve
2 1/2 - 36", class 3 600 | Edward FLOWSERVE

The Flowserve Edward Equiwedge Gate Valve is large bore and created with body guided, split wedges that offer superior leak tightness and performance. These and other features allow this gate valve to work proficiently and consistently. These features include:

Reduced torque, thread wear and eliminated galling because the material used has a low coefficient of friction
Ready access to the packing chamber
Optimum seal ability and life due to the use of a flexible graphite packing material with anti-extrusion rings
Long, reliable service with the pre-loaded, pressure energized design
Reduced friction for longer valve life due to the integral hard faced guide system components
Additional support for side loads imposed by the handwheel or the power actuator with the tapered roller bearings found on larger valves. Smaller size valves have needle roller bearings
ACME threads
Effective, tight seal established by pulling the bonnet and gasket together at the pressure seal
Easier field maintenance of the upper structure without disturbing the pressure containing parts. Valves in smaller sizes utilize a wishbone yoke design. Class 600 valves utilize a bolted pressure seal bonnet
Hard faced to assure long-term seal ability
Each wedge half is able to flex and adjust independently to compensate for body distortions caused by thermal changes or pipe bending stresses (See pg. 25)
Prevention of leakage because the seat ring is welded into the valve body

Available in classes 600 to 3600 from sizes 2-1/2 to 36 inches.