Wire mesh sieve
GANTOIS INDUSTRIES
The accuracy and the truthfulness in granulometric analysis are requirements that GANTOIS satisfies with its wire meshes and perforated sheets.
The test sieves with STAINLESS STEEL mountings satisfy the standards:
NF ISO 3310/1; 3310/2; ASTM E11 70
The range of opening is graduated from 20 microns to 3.55 mm in woven base and 4 to 125 mm in perforated base (square hole with reserved border).
The standardised dimensions extend from Ø 45 useful height 30 mm to Ø 450 Height 100 mm.
Contact us for other forms and dimensions.
The quality system applied on these products is certified ISO 9001/Version 2000.
GANTOIS can produce a listing of measurements on demand from measurement instruments connected to the international measurement system.
The standard sieves are certified by COFRAC and UKAS accredited laboratories.
GANTOIS can also provide the verification of test sieves IN SERVICE for the mountings Ø 45 to 315 mm maxi.
Reference standards: ISO -AFNOR-ASTM
GANTOIS can offer containers (base) and covers for all standard dimensions.
OUR STRONG POINTS:
* The tolerances of wires and in the fabrication of GANTOIS combs, allow obtaining the recommended diameter according to standards.
* Selection and stringent testing during each operation.
* The non deformability of meshes.
* Uniform and measured tension of sieve bottoms.
* Sliding on top of any other standardised sieve.
-
zoom
