Vertical cylindrical grinding machine
max. ø 130 mm | ZS 151, ZS 201
HENNINGER PRÄZISION
The centre hole is the basis for all the following cylindrical grinding operations and the deciding factor for the quality of the complete workpiece.
Inherent workpiece errors such as out-of-roundness, misaligned centres, incorrect angles ( too large ot too small ) and surface finish roughness caused byprior chip removal or hardening operations can be corrected.
The scrap level incidence in production runs is significantly reduced by the improved repeatability of ground centres.
Advantages of centre grinding operations
* higher process stability
* econmic efficiency
* low reject rate
* higher accuracy
Inherent workpiece errors such as out-of-roundness, misaligned centres, incorrect angles ( too large ot too small ) and surface finish roughness caused byprior chip removal or hardening operations can be corrected.
The scrap level incidence in production runs is significantly reduced by the improved repeatability of ground centres.
Advantages of centre grinding operations
* higher process stability
* econmic efficiency
* low reject rate
* higher accuracy
