The Innomatec connec ® Quick Connector System closes pipes, connecting pieces, tubes, drill holes, outer threads, inner threads and all types of cylindrical bodies, but it can also connect you to a desired circulation system. Oval, rough and cast surfaces along with high tolerances samples are radially sealed. The innomatec connec ® Quick Connector System can be loaded with a sample manually or with an automatic tool. The Quick Connection is pneumatically activated with a pressurized air system. Sealing occurs with an elastic rubber washer. The system is filled or sealed through the tested connection. After the test is complete, the test connection is depressurized, the sealing ring relaxes, and the connection can be removed. Whether the connection must be armed with a sliding barrier depends on diameter, working pressure, and surface properties (oiled, etc.). The innomatec connec ® Quick Connector System has an excellent degree of sealing (and is “helium-proof”). The standard lives of the sealing rubber washers are appropriated depending on routine aptitude. The change in the sealing rubber washers can be very easy and does not necessitate the use of tools. There are a number of special inplementations for specific uses with motion limitation, sliding barriers, support hulls for specific environmental conditions. For specific utilizations, the connection measurements and individual parts can be adjusted to the task. We welcome any of your questions. Please use our checklist for this purpose.