Suction oil filter
max. 10 bar | TRS 625 INTERNORMEN Technology

The filters of the series TRS are tank-top mounted in-line filters. In addition to the return-line connection they have a suction connection on the clean-side. This suction connection has a preload pressure (fitting pressure) of ≥ 0,5 bar.
This combination, return-line and suction filter, is foreseen for hydraulic circuits which are equiped with minimum 2 feed pumps (2 hydraulic circuits). The preload suction connection is for the full volume flow filtration for the pump with the smaller volume flow.
The operating status in general wherein the preload pressure and the full stream filtration are effecting the QR (return-line flow) > QS ( suction flow). When the operating status is QR = QS no preload pressure is effective. For circuits wherein the operating status QR < QS appears for a short time, the suction valve operates and as a result a feeding out of the vessel is possible without preload pressure and without
filter effect.
Return-line filters in the TRS series are suitable for a working pressure up to 10 bar. Pressure peaks will be absorbed by a sufficient margin of safety.
The filter element consists of a star-shaped, pleated filter material which is supported on the inside by a perforated core tube and is bonded to the end caps with a high-quality adhesive. The flow is from outside to inside. Filter finer than 40 μm should use throw-away elements made of paper or Interpor fleece (glass fibre). Filter elements as fine as 5 μm (c) are available; finer filter elements on request.