Brushless motorized roller
25 W, 0.03 - 0.98 m/s | EC200 Interroll

RollerDrive EC200 is equipped with an integral motor control which fulfills all required commutation- and safety functions. Independent from load on the conveyor, EC200 runs always with the same speed featuring a true four-quadrant- motion controller.
EC200 can be used with out any external control electronic. By using a combined analog Signal (0 -10V), speed and start is set. This input is valid up to 28 V, which makes it very easy to control the EC200 with a simple relay, so that it runs at full speed.
There is also a compact interface box available, to simplify the speed setting and decouple the signals.

Characteristics
- 25 Watts continuous mechanical performance
- Integral commutation electronic
- Constant conveyor speed
- After run reducing motor stop function
- 15.000 hours minimum operation time
- Protection rate IP54 or IP66
- 55 dB(A) noise emission mounted in conveyor
- 450 mm cable length
- 5 pole Fixcon connector