Adhesive dispensing unit
7 - 68 bar | APEX™
ITW Dynatec
ITW Dynatec's APEX High Speed Slot Die Applicator is an air-operated hot melt adhesive applicator assembly with an optional filter manifold. The applicator is used with intermittent pressure and constant pressure hot melt adhesive supply units (ASUs). APEX models are offered in six different module configurations.
* Maximum on/off cycle speed 10,000 cycles per minute
* Application width up to 500 mm / 19.6 in.
* Adhesive viscosity 100 cps min / 20,000 cps max
* Maximum operating temperature 200°C / 390°F
* Pneumatic pressure 74 psi (5 bar) min / 125 psi (9 bar) max
* Adhesive pressure 100 psi (7 bar) min / 1,000 psi (68 bar) max
* 230 VAC, 50/60 Hz, 1 phase with 24 VDC control voltage (custom configurations available)
* Maximum on/off cycle speed 10,000 cycles per minute
* Application width up to 500 mm / 19.6 in.
* Adhesive viscosity 100 cps min / 20,000 cps max
* Maximum operating temperature 200°C / 390°F
* Pneumatic pressure 74 psi (5 bar) min / 125 psi (9 bar) max
* Adhesive pressure 100 psi (7 bar) min / 1,000 psi (68 bar) max
* 230 VAC, 50/60 Hz, 1 phase with 24 VDC control voltage (custom configurations available)
