The driver and temperature controller is a highly precise, safe and cost effective solution for driving diode lasers in pulsed or cw mode. The driver is completely controllable by the RS232 serial interface. You can freely set Current, Voltage and Temperature Limits. The device contains an On-Board Oscillator, which you can freely configure for pulsing the laser. The temperature controller is based on a PID-Control-Loop. The temperature sensor can be NTC, PT100 or other and can be adjusted by software. Each device passed our 24h Full Power Burn in and several safety tests for proving static discharge and AC line transient protection.

• LD supply up to 50A / 3V
• TE cooler supply up to 9A / 18V
• non volatile preconfiguration (EEPROM)
• external control by RS232 serial interface
• 24h Burn-In
• external analogue (BNC) / digital (TTL level)modulation up to 5kHz
• PID controller for NTC closed loop operation (other sensors available on request)
• internal oscillator for pulsed operation up to 5kHz
• manual adjustment via front panel and softkeys
• Interlock, emergency contact and key switch
• extremely compact 19x14x30 [cm]