Stepper motor driver
15 - 150 V, 6 - 12 A | SMD15, SMD30
JVL
A wide selection for any application
JVL Drivers are controlled by either external step- and direction control signals, or by a built-in step-signal generator. The latter can be used, depending on model, to control motor speed and direction using input control signals.The Drivers are equipped with inputs and outputs for clockwise- and counter-clockwise end-of-travel inputs (CW/CCW Limit Inputs), Break, Status, Start and Stop, as well as provision for adjusting start speed, acceleration/deceleration ramps and 2 tops speeds in the same operation.
- Driver stages of 6 and 12 A, and 15-150V
- Top velocity can be controlled using external voltage (0-5/0-10V)
- Phase current can be controlled using external voltage (0-5V)
- Stop input which stops motor operation instantaneously
- Status output which indicates motor is running or stationary
- CW/CCW end-of-travel inputs
- Facility for 2 velocities in same motor operation
- 200, 400, 800 or 1600 steps per revolution (full-, half, 1/4 or 1/8 step operation)
- All in/outputs optically isolated
- Adjustment of stand-by current
- Adjustment of operating current
- External switching between operating and stand-by current
- LED indication of motor operation
- Error-, Step-pulse- and Direction output
-
zoom
