Once the vehicle floor has been lifted and the edge of the dock leveller has been placed on the truck floor, it follows the lifting and dropping of the vehicle (according to the operation that the operator is carrying out: if during loading or unloading) as well as any unbalanced side load by performing a torsion of up to 100mm.
Electro hydraulic dock levellers with telescopic lip are used in the case of side loading of the vehicle or rear loading onto a container.
They are produced in a standard mode with the following dimensions:
A Width from 2000 to 2200 mm
B Length from 2500 to 3000 mm
H Height from 470 to 800 mm
L Length of the edge from 400, 1000 mm
The Kopron loading ramps are designed with a specific goal: they are solid, sturdy and reliable. Our technicians study the critical points and design the very best solutions to achieve the highest possible level of reliability.
The Kopron loading ramps are available in standard dimensions but may have personalised dimensions in order to adapt to Customer requirements.
For situations in which the weight to be supported for the loading ramps is high, Kopron designs and creates special ramps with a greater loading capacity, capable of supporting even the most extreme situations.
Apart from being structurally solid and reliable, all of the Kopron products follow unique and recognisable styles and designs.