Rodless pneumatic cylinder
ZFB Lanamatic AG

- Well-tested technique of locking units
- Gripping stronger than action power of cylinder
- Locking unit with external slide guide
- Locking unit can be mounted later
- Locking unit can be easily replaced
- Small construction height
The holding power Fb mentioned in the data sheet refers to statistical capacity only. A sliding can occur if you do not adhere to this maximum figure.
The powers acting in such a dynamical use may under no circumstances go above the statistical figures.
In addition to that the holding powers can be slightly diminished if the guide rod is not dry.
For use with rodless pneumatic cylinder we generally recommend control with 5/3 way valve with open middle position.
The valve control must be adjusted in such a way that for a stop in between the yoke must be geared with air pressure on both sides and only then can the safety unit be switched pressureless.
While releasing, the cylinder should also be under pressure on both sides to avoid a jerky movement of the yoke (danger of accident).