Magnetic float level switch 3 ASME series
displacerfor liquidsATEX

magnetic float level switch
magnetic float level switch
magnetic float level switch
magnetic float level switch
Add to favorites
Compare this product
 

Characteristics

Technology
magnetic float, displacer
Medium
for liquids
Approvals
ATEX
Material
carbon steel
Process temperature

Max.: 538 °C
(1,000 °F)

Min.: -46 °C
(-51 °F)

Process pressure

115.8 bar, 154.4 bar
(1,679.54 psi, 2,239.38 psi)

Description

Series 3 ASME B31.1 float-actuated level switches are designed, built, and certified to the requirements of ASME B31.1 power piping codes. They are ideal for critical alarm set points in clean liquid applications. Series 3 ASME B31.3 float and displacer-actuated level switches are designed, built, and certified to the requirements of ASME B31.3 power piping code requirements. They are ideal for critical alarm set points in clean liquid applications. Series 3 NACE float and displacer-actuated level switches are designed, built and certified to meet NACE MRO175 and MRO103 requirements. They are ideal for alarm and control set points in sour liquid applications. All welding is performed by qualified welders and per procedures required by the ASME Boiler Pressure Vessel Code Sec. IX. Carbon steel pressure boundary parts are post weld stress relieved. All welds and heat-affected zones are hardness tested to ensure compliance with NACE maximum hardness requirements. A permanent magnet is attached to a pivoted switch actuator. As the float/displacer rises following the liquid level, it raises the attraction sleeve into the field of the magnet, which then snaps against the non-magnetic enclosing tube, actuating the switch. The enclosing tube provides a static pressure boundary between the switch mechanism and the process. On a falling level, the float/displacer deactivates the switch. Models built to ASME B31.1, ASME B31.3, and NACE MR0175/MR0103 construction 14-inch (356 mm) side/side process connections available as standard Specific gravity ratings as low as 0.33 Choice of TYPE 4X/7/9, Group B, C & D or EEx d IIC T6 housings Agency approvals include FM, CSA,

Other Magnetrol - AMETEK products

Level control

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.